Bloom yoga User Manual download pdf (Page 13)

2

eng

open). You will hear an audible click. (refer to

illustration 3)

To install nest

– Unfasten all zippers on the nest fabrics, and

position inside frame. The larger body section

should ﬁt onto the side with canopy arch.

(refer to illustration 4)

– Fasten the two zippers on fabric rim around

nest frame. (refer to illustration 5)

– Place mattress into nest and thread the

shoulder, waist and crotch harness straps

through the corresponding slots on the

mattress. (refer to illustration 6 & 7)

To use and adjust safety harness

– To lock the harness, push the tongues on the

ends of the waist straps, connected with the

ends of the shoulder straps, into the buckle on

the crotch strap until locked.

– To unlock the harness, press the central

button. (refer to illustration 8)

– SAFETY NOTE: Every time you place your child

in stroller or whenever you alter the position

of the seat, always check that the harness is

correctly ﬁtted. Tighten the harness until it ﬁts

snugly.

To install canopy

– Attach canopy fabrics to canopy arch by

fastening the two zippers on either side. (refer

to illustration 9)

– Attach canopy fabrics to nest frame by pairing

and fastening the zipper on the bottom of

canopy to the zipper on the outer rim of nest

fabrics.

To use canopy

– The canopy can be used in 3 positions:

retracted, half opened, fully open.

Simultaneously press the two buttons on both

sides of canopy arch to adjust angle.

– When using canopy in half opened mode,

fasten zipper on canopy to tug away loose

fabric. (refer to illustration 10)

Section B: Carry Cot Mode

– Fasten the two zippers located in the middle

and the head section of the nest body. (refer

to illustration 11)

IMPORTANT! Middle and head section

zippers must be properly fastened to ensure

correct angle for baby

– To attach nest shield, wrap elastic edge over

top of nest and fasten the two string loops on

either side of nest shield to the nub on frame.

(refer to illustration 12)

Section C: Bouncer Mode

– Unfasten middle zipper of nest body.

– Fasten zippers on both ends of nest body.

(refer to illustration 13)

– Disengage lock lever, then press the button on

direct opposite side of lock lever. Rotate the

head section of nest body upward. You will

hear an audible click.

– Engage lock lever to lock frame. (refer to

illustration 14)

– You can rock the cradle by applying a push

either on the canopy arch or on the front of

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments